Panasonic DMC-FZ1000 - Manual (Page 153)

153
6. Focus and Brightness (Exposure) Settings
∫ Displaying the MF Assist
• It is displayed by rotating the manual ring.
• It can also be displayed by pressing 2 to display the setup screen for the enlarged area,
deciding the area to enlarge using the cursor button, and then pressing [MENU/SET].
• It will switch to the setting screen for the enlarged area by pressing the cursor button when the
[Direct Focus Area] in the [Custom] menu is set to [ON].
∫ Changing the display of the MF Assist
Each time the rear dial is pressed, an enlarged display switches between a windowed
screen display and a full screen display.
• If the rear dial is rotated, the display can be enlarged/reduced up to approximately 3 to 6 times
when the enlarged display is in a windowed display or up to approximately 3 to 10 times when
the enlarged display is in a full screen display.
The rear dial enlarges/reduces the size at a rate of 1 time.
∫ Moving the enlarged area
• The enlarged area can be moved by pressing the cursor button.
• The following will return the MF assistance to the original position.
– Pressing [DISP.] when the setting screen for determining the area to be enlarged is displayed.
∫ Closing the MF Assist
• It will close when the shutter button is pressed halfway.
• You can also close MF Assist by pressing [MENU/SET].
• If you have displayed the MF Assist by rotating the manual ring, it will close approximately
10 seconds after you stop operating the camera.
Not available in these cases:
• The MF Assist is disabled in the Digital Zoom range or when recording motion pictures.
MF ASSIST