Panasonic DMC-FZ1000 - Manual (Page 179)

179
7. Shutter and Drive Settings
• This function is not for use in a security camera.
• If you leave the unit somewhere to perform [Time Lapse Shot], please be careful of theft.
• Recording for long periods in cold places such as ski resorts or places at high altitude,
or in warm, wet environments may cause a malfunction, so please be careful.
• Recording may not be consistent with the set recording interval or the set number of pictures
depending on recording conditions.
• Recording may be skipped when the recording time is longer than the recording interval, such
as long time exposure.
• We recommend that you use a sufficiently charged battery or an AC adaptor (optional) and a
DC coupler (optional).
• [Time Lapse Shot] is paused in the following cases.
During [Time Lapse Shot], you can replace the battery and the card, and then restart by turning
on this unit. Turn off this unit when replacing the battery or the card.
– When the charge on the battery runs out
– Turning the camera off
• Do not connect the AV cable (optional), the HDMI micro cable, or the USB connection cable
(supplied) during Time Lapse Shooting.
• When a picture quality different from the aspect ratio of the original pictures is selected, black
strips will be displayed on the top and bottom or the left and right of the motion picture.
• If power supply is lost by unplugging the AC adaptor or due to a blackout while creating a
motion picture with the AC adaptor, the motion picture you are creating will not be recorded.
• A motion picture that exceeds the recording time of 29 minutes and 59 seconds and a motion
picture that exceeds the file size of 4 GB cannot be created.
• When only one picture is taken, it will not be saved as a group picture.
Not available in these cases:
• This function is not available in the following cases:
– [Handheld Night Shot]/[Panorama Shot] (Scene Guide Mode)
– [Multi Exp.]