Panasonic DMC-FZ1000 - Manual (Page 290)

12. Using the Wi-Fi function
290
Search for available wireless access points.
•
Confirm encryption key of the selected wireless access point if the network authentication is
encrypted.
• When connecting by [Manual Input], confirm SSID, encryption type, encryption key of the
wireless access point you are using.
1 Select the wireless access point you are connecting
to.
•
Pressing [DISP. ] will search for a wireless access point
again.
• If no wireless access point is found, refer to “ When
connecting with [Manual Input] ” on P290 .
2 (If network authentication is encrypted)
Enter the encryption key.
•
For details on how to enter characters, refer to “ Entering Text ” section on P55 .
∫ When connecting with [Manual Input]
1 On the screen displayed in step 1 of “If you are not sure about the WPS
compatibility (connecting by [From List])”, select [Manual Input].
2 Enter the SSID of the wireless access point you are connecting to, then select
[Set].
•
For details on how to enter characters, refer to “ Entering Text ” section on P55 .
3 Select the network authentication type.
•
For information on network authentication, see the manual of the wireless access point.
4 Select the encryption type.
•
The type of settings that can be changed may vary depending on the details of network
authentication settings.
5 (When an option other than [No Encryption] is selected)
Enter the encryption key.
• Check the wireless access points instruction manual and settings when saving a wireless
access point.
• If no connection can be established, the wireless access point’s radio waves may be too weak.
Refer to
“ Message Display ” (P330) and “ Troubleshooting ” (P343) for details.
• Transmission speed may decrease, or may not be usable depending on the environment it is
used in.
If you are not sure about the WPS compatibility (connecting by [From List])
Network authentication type Encryption types that can be set
[WPA2-PSK]/[WPA-PSK] [TKIP]/[AES]
[Common Key] [WEP]
[Open] [No Encryption]/[WEP]