Goulds Pumps 3796 i-FRAME - IOM User Manual
Page 57
Advertising
The annular groove in the coupling guard half must face the motor.
Annular
Driver
Guard half
groove
6. Place the driver-side end plate over the motor shaft.
Driver
End plate
7. Place the driver-side end plate in the annular groove of the driver-half of the coupling guard.
8. Use a bolt, a nut, and two washers to secure the coupling guard half to the end plate. Hand-tighten
only.
The hole is located on the driver-side of the coupling guard half.
9. Slide the driver-half of the coupling guard towards the motor so that the coupling guard completely
covers the shafts and coupling.
Commissioning, Startup, Operation, and Shutdown (Continued)
Model 3796 i-FRAME Installation, Operation, and Maintenance Manual
55
Advertising