Bearing-housing inspection – Goulds Pumps 3796 i-FRAME - IOM User Manual
Page 89
Bearing-housing inspection
Checklist
• Inspect the bearing-housing (134) bore according to the bearing fits and tolerances table.
• Replace the bearing housing if the dimensions exceed acceptable values. Reference: see Bearings fits
and tolerances.
• Visually inspect the bearing housing for cracks and pits.
Checklist for specific models
This table shows bearing-housing checks that are required for specific models of pump.
Frame
Bearing-housing check
STi and MTi
Ensure that the snap-ring groove is not cracked.
LTi
Clear all grooves and holes.
Inspection locations
The following images point to the areas to inspect on the bearing housing.
134
Figure 26: STi and MTi bearing housing
134
Figure 27: LTi bearing housing
Maintenance (Continued)
Model 3796 i-FRAME Installation, Operation, and Maintenance Manual
87