Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 11)

Rev. 1/13 Page 11 of 19 SB
11635.10
Step 38. Hold the door jam cover supplied in place over the
front section of the wheel well behind the rear door.
Panel should cover area previously modified. If the
door jam cover does not fit smooth and line up with
the door jam then more bending modification will be
needed to wheel well. With cover in place mark the
two mounting holes. Remove cover and drill marked
areas with a 3/32” drill bit. Attach panel using the
supplied phillips head screws.
Step 39. Hold the flare against the body using slight pressure
to check fitment. Some trimming and sanding may be
necessary to flare may be needed to ensure a smooth fit
to the body. Once the correct fit is achieved trace a line
onto the lower body cladding of the rear door. This area
of the cladding will be cut to match the curve of the
flare.
Step 40. Remove the retainer nut from the backside of the
rear door that holds the lower body cladding on
to the vehicle.
Step 37. Remove all loose paint chips and sand rough areas.
Mask off area and coat with a rust inhibiting paint.