Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 2)

Rev. 1/13 Page 2 of 19 SB
11635.10
Step 1. Remove front wheel from vehicle.
Note: Refer to factory owners manual for proper procedures for
wheel removal. Jack stands and wheels chocks are
recommended during flare installation.
All steps shown in the following instructions will only be
illustrated on one side. Repeat each step for opposite side
of vehicle.
Step 2. Remove the cladding from the rear of the front fender
wheel well. Cladding is held on with three screws in the
wheel well.
Step 3. Once screws have been removed cladding will snap off
from vehicle. Remove cladding and retainer from
vehicle. Discard cladding and retainer. There are two
mounting pins on the fender. These may need to be
trimmed from vehicle to ensure proper fitment. Treat
any unpainted surfaces to prevent rust.
Step 4. Remove lower rocker panel cladding (if equipped).
Cladding is held on with one screw and plastic fastener.
Discard cladding.
Front Flare Installation Procedures.