Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 17)

Rev. 1/13 Page 17 of 19 SB
11635.10
Step 62. Reinstall the rear bumper cover splash shield using
the factory hardware previously removed. Attach the
lower rear portion of the fender flare to the two L
brackets on the rear bumper cover using two plastic
push rivets.
Step 61. Drill holes marked on fender using a 3/16” drill bit.
Refer to steps 21-24 for mounting procedures.
Step 63. Using a 3/32” drill bit, make pilot holes into the fender
well using the pre-drilled holes in the fender flare as
a guide.
Step 64. Secure the flare to the wheel well using the supplied
#8 screws. Do not over tighten screws.