Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 14)

Rev. 1/13 Page 14 of 19 SB
11635.10
Step 49. Assemble the rear and middle wheel arch flares. Align
the two rear flare sections by the three style line areas
indicated. Once the pieces are aligned mark the holes
on the inside mating lip from one flare to the other
flare. Drill holes with a 1/4” drill bit.
Step 50. Attach the rear and middle wheel arch flare sections
using the supplied bolts and lock nuts with a washer
on each side of the flare flange.
Step 52. Hold the assembled rear sections of flares against the
body aligning the front area of the flare to the body
crease behind the rear door opening. Adjust the flare
to achieve a 1/4” gap between the wheel arch flare and
the door flare.
Step 51. Hold assembled flare sections in place on the vehicle.
Due to the multiple body cladding styles the flares
may not have a completely flush fit. Some sanding
and contouring may achieve desired results. Use
caution when modifying flares. Do not remove
material from around bolt hole mounting areas.