Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 5)

Rev. 1/13 Page 5 of 19 SB
11635.10
Step 13. Mark the inner fender well flange for trimming.
Starting at the bottom of the inner fender flange place
a mark 12 inches up from the bottom. Draw a vertical
line similar to the line previously drawn on the outer
fender. Make multiple horizontal marks 1 to 2 inches
apart.
Step 14. Using a cutoff wheel or sawzall cut the lines made on
the inner fender well. Cut only the horizontal lines
from inside of the fender well to the vertical line
drawn. Use caution when cutting. Do not over cut or
cut into surrounding areas.
Step 15. Bend the cut tabs inward towards the fender well.
Using and hammer bend them as close as possible
to the fender well. Flatten all sharp areas. Remove all
loose paint chips and sand rough areas. Mask off area
and coat with a rust inhibiting paint.
Step 16. Re-install the inner wheel well sound dampening foam
into the rear portion of the wheel well.