Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 4)

Rev. 1/13 Page 4 of 19 SB
11635.10
Step 9. Using a cutoff wheel or sawzall cut the lines made on
the fender. Cut only the horizontal lines from inside
of the fender to the vertical line drawn. Use caution
when cutting. Do not over cut or cut into surrounding
areas.
Step 10. Using pliers bend the cut fender well lip out. Bending
only one section at a time bend the lip out so that it
creates a flat even surface flush with the outside of the
fender.
Step 11. Bend the tabs inward. The tabs should start at the
line drawn and should be bent inward 90 degrees
towards the fender well duplicating the factory bend.
Step 12. Remove all loose paint chips and sand rough areas.
Mask off area and coat with a rust inhibiting paint.