Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 13)

Rev. 1/13 Page 13 of 19 SB
11635.10
Step 45. Hold the flare against the body using slight pressure
to check fitment. Some trimming and sanding to the
flare may be necessary to ensure a smooth fit to the
body. Once the correct fit is achieved mark the
mounting holes on to the body using the holes in
the flare as a guide.
Step 46. Drill holes marked on fender using a 3/16” drill bit.
Refer to steps 21-24 for mounting procedures.
Step 47. With the flare installed snap the rear door panel in
place. Additional trimming may be needed for proper
fitment.
Step 48. Install the lower rear rocker panel end cover. Mark the
mounting holes for the lower rear rocker panel end
cover. The cover is held on with two self tapping
screws on top and bottom of the cover and one body
mounting bolt on the front.