Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 7)

Rev. 1/13 Page 7 of 19 SB
11635.10
Step 21. Clean inside mounting lip edge with rubbing alcohol.
Install edge trim as shown by removing red vinyl tape
covering only a few inches at a time. Do not stretch
the trim while being applied, this may cause shrinkage
after installation.
Step 22. Place a washer on each bolt and insert them into the
pre-drilled holes in the flare. Place a rubber spacer on
each bolt on the inside of the flare.
Step 23. Position flare against the body over the drilled
mounting holes. Start each screw into the mounting
holes. Once each screw has been started, snug the
flare to the body. DO NOT TIGHTEN.
Step 24. Torque each bolt to 24 in-lbs (2 ft-lbs). Do not over
tighten. Over tightening could cause damage or
warpage.
NOTE: The following steps will be repeated for each
flare section.