Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 16)

Rev. 1/13 Page 16 of 19 SB
11635.10
Step 57. With the flare held in place against the body, move the
flare slightly to the rear of the vehicle to expose a
portion of the rear bumper cover. There are two
mounting holes on the inner rear lower portion of the
flare. Mark these two holes 1/4” back from the cut edge
onto the bumper cover.
Step 58. Drill two mounting holes into the rear bumper cover
using a 3/16” drill bit.
Step 59. Attach the L shaped brackets to the rear bumper cover
as shown. The brackets will mount to the inside of the
bumper cover and using a bolt and nut with a washer
on each side of the bumper cover.
Step 60. Hold the flare against the body using slight pressure
to check fitment. Some trimming and sanding may be
necessary to ensure a smooth fit to the body. Once the
correct fit is achieved mark the mounting holes on to
the body using the holes in the flare as a guide.