Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 9)

Rev. 1/13 Page 9 of 19 SB
11635.10
Step 29. Remove rear wheel from vehicle.
Step 30. Draw a line on the top edge of the section of trim
located at the front of the rear wheel well opening
next to the rear door edge.
Step 31. Remove the section of trim from the front of the rear
wheel well opening that is located next to the rear
door edge.
Note: Refer to factory owners manual for proper procedures for
wheel removal. Jack stands and wheels chocks are
recommended during flare installation.
All steps shown in the following instructions will only be
illustrated on one side. Repeat each step for opposite side
of vehicle.
Step 32. If your vehicle is equipped with a plastic rocker panel
cover, you will need to draw a vertical cut line and
trim the cover. The line will need to start from the
bottom point of the door trim and extend downward.
A razor knife will be suitable for trimming. Ensure the
cut is smooth, this area will be visible after the flare is
installed. After trimming, the panel cover should be slid
forward slightly or removed when cutting the body.
Rear Flare Installation Procedures.