Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 3)

Rev. 1/13 Page 3 of 19 SB
11635.10
Step 5. Remove the front wheel well liner. Liner is held in by
plastic fasteners. Use caution as not to damage
fasteners when removing. The fasteners will be reused
later to reinstall the liner.
Step 6. Remove the inner wheel well sound dampening foam
from the rear portion of the wheel well. Do not discard
foam, it will be reused later. If any debris is present it
must be removed before proceeding.
Step 8. Mark vehicle for trimming. Starting at the rear of the
front fender at the bottom of the vehicle at the pinch
weld draw a vertical line 1 9/16 inch from the wheel
well opening back towards the rear of the vehicle. The
line should continue upward to the first body crease
maintaining a 1 9/16 inch distance. The line should
then continue upward tapering to 1/8 inch at where
the top of the cladding was previously removed. Make
multiple horizontal lines as shown in the image. These
will be used as a guide for cutting.
Step 7. Remove the lower fender bolt located at the bottom rear
of the front fender. Measure 2 inches back from the hole
towards the rear of the vehicle. Drill a 3/16” pilot hole.
Reinstall the bolt removed previously.