Rugged Ridge Fender Flare Kit, 93-98 Jeep Grand Cherokee (ZJ) - Manual (Page 19)

Rev. 1/13 Page 19 of 19 SB
11635.10
NOTICE: Do not use any harsh chemicals on flares. Use only plastic
approved cleaning chemicals.
CUT OUT FLARE PAINT PREPARATION:
Step 1. Lightly sand flares with 320 grit sandpaper.
Step 2. Remove all surface contaminants from flares
using an approved grease and wax remover.
Step 3. Wipe flares with a tack rag to remove any dust
or dirt.
PAINTING
Step 1. Apply two even coats of adhesion promoter to
flares. Allow recommended flash time between
coats. Let second coat dry for 15 minutes before
primer application.
Step 2. Apply an even coat of primer to flare surface.
( A high build primer is recommended. )
Step 3. Paint flares with a automotive grade paint.
( A flex additive must be added to paint. )
For Technical Assistance Contact:
OMIX-ADA Tech Support
Phone: 1-800-449-6649
E-mail: [email protected]
Web: www.Omix-Ada.com
Copyright Omix-Ada 2011