ADTRAN MX2800 M13 - Manual (Page 193)

61200290L1-1G I-1
I NDEX
Index
Numerics
24 Hour Alarm History
DS2 Statistics menu 5-9
DS3 Statistics menu 5-2
A
acknowledgment messages
All Right 9-3
In Progress 9-3
ACT LED, active cards 2-16
ACT LED, standby cards 2-17
Active Controller menu 3-6
Active state, Card A/Card B 4-5
agent, SNMP 1-3
AIS
24 Hour Alarm History (DS3 statistics) 5-2
Remote status 4-3
State, DS2 4-6
State, DS3 4-2
AIS Carrier Alarms 5-13
AIS Loop Alarms 5-13
alarm events 9-11
Alarm Log 5-14
Alarm menu
DS3 State 4-2
System State 4-4
alarms
system 3-34
ALM LED, active cards 2-16
ALM LED, standby cards 2-17
Analog Loopback, remote all T1/E1 6-8
Analog Network loopback test 6-3
Answer on Ring menu 3-20
Auto Save menu 3-38
autonomous messages 9-4 , 9-11
B
backup protection
non-redundant power mode 8-1
power supply and source recovery mode 8-2
power supply recovery mode 8-2
battery backup, overview 1-4
Battery Low, Power Supply State 4-4
baud rate, setting 3-20
BERT
CSU Loopback w/ 6-4
Line 6-5
Bipolar Violations 5-13
blue alarm
DS2 State 4-6
network state 4-2
Remote status 4-3
breakout panel
overview 1-3
C
CAIS
T1/E1 State 4-6
Card A/Card B
Active state 4-5
Failure 4-5
Not Installed 4-5
Stand By 4-5
Card A/Card B menu 4-5
Card Comm menu 4-5
Card Failure
System State Alarm 4-4
C-Bit Coding Violations (CCV) 5-8
C-Bit Errored Seconds (CES) 5-8
C-bit parity
remote loopback 6-4
C-Bit Severely Errored Seconds (CSES) 5-8
Charger Fail, Power Supply State 4-4
circuit protection mode 4-5
Clear All Local DS3 Statistics 5-9
Clear All T1/E1 Alarm Counts 5-13
clearing statistics 5-9
codec line/net loopback 6-4
Common Eqpt Fail (NSA) Remote status 4-3
Configuration menus
Network Interface 3-4
Save Configuration 3-44
Utilities 3-38
Connection Timeout menu 3-20