Terminal time out, Ip security, Ip hosts – ADTRAN MX2800 M13 User Manual
Page 73: Date and time, Miscellaneous, Alarm relay configuration, Terminal time out -33, Ip security -33 ip hosts -33, Date and time -33 miscellaneous -33, Alarm relay configuration -33
MX2800 M13 Multiplexer User Manual
Configuration, Section 3
61200290L1-1G
3-33
Terminal Time Out
Set the amount of time the terminal or Telnet session remains inactive before automatically closing the
session, requiring the user to log in again. Options include the following:
• Disabled
• 1 min.
• 5 min.
• 15 min.
• 60 min.
• 1 day.
IP Security
Enable or disable the
IP Security
option. If IP Security is set to Enabled, the unit accepts management
commands and Telnet sessions from the IP addresses entered into the
IP Hosts
fields.
IP Hosts
Enter up to 16 IP addresses of management stations from which the unit should accept management
commands. These addresses are applicable only if IP Security is Enabled.
Date and Time
Enter date and time information. Enter the month, date, and year separated by forward slashes (02/23/04).
Enter the time in military time separated by colons (13:15:25).
Miscellaneous
The Miscellaneous option of the System management menu sets the fields and values for the
• Alarm Relay Configuration
• Equipment Identification
• Syslog Setup
• Auto Save
• Craft baud rate
Alarm Relay Configuration
This menu enables and disables audible and visible alarms for specific error conditions. See
.