Network interface, Ds3 configuration, Framing – ADTRAN MX2800 M13 User Manual
Page 44: Line length, Network interface -4, Ds3 configuration -4, Framing -4 line length -4, Figure 3-3. network configuration menu -4
3-4
61200290L1-1G
Section 3, Configuration
MX2800 M13 Multiplexer User Manual
2. NETWORK INTERFACE
Select
Network Interface
to access the network configuration parameters. See
. Configure the
MX2800 network settings to match the DS3 signal received from the service provider.
Figure 3-3. Network Configuration Menu
DS3 Configuration
The DS3 Configuration selections are used to configure the DS3 network settings to match the desired
application. Descriptions of these settings are explained below.
Framing
The framing format is used to match the format of the receive signal at the network interface. The MX2800
supports C-bit and M13 framing formats.
NOTE
M13 may not be selected when IP Forwarding is active.
Line Length
The line length is set to reflect the physical length of the DS3 network line.
• Long should be used if the cabling distance exceeds 225 feet.
• Short should be used if the distance is less than 225 feet.