ADTRAN MX2800 M13 - Manual (Page 79)

MX2800 M13 Multiplexer User Manual Configuration, Section 3
61200290L1-1G 3-39
Loading Default Settings
Select Load Default Settings from the Utilities menu. Three options are available for loading default
settings.
Load Default Settings Other Than System Management
This option defaults all Network and T1/E1 interfaces but does not change management-related options.
Refer to
Management Options on page 3-17 for the management-related options.
CAUTION
Loading the default settings will set the T1/E1 state of all DS1 ports to
Auto Enable .
Load System Management Default Settings
This option defaults all management-related settings but does not default settings for Network and T1/E1
interfaces.
CAUTION
Loading the default settings will set the T1/E1 state of all DS1 ports to
Auto Enable. The User Account Management table is also reset to default.
Table 3-7. Self-Test Results
If the self test results are... Then...
PASS The self-test was successful and the unit is ready to use.
BAD RAM DATA
BAD RAM ADDRESS
BAD CODE CHECKSUM
BAD BOOT SECTOR
IOX PROGRAM FAILURE
AFE PROGRAM FAILURE
MODEM FAILURE
ETHERNET FAILURE
DS3 FAILURE
DSX FAILURE Contact ADTRAN Technical Support. For more information, refer to
Appendix F, Warranty .
CONFIGURATION CORRUPT Select Save Configuration from the Configuration menu. If the condition
persists, contact ADTRAN Technical Support.