4 eeprom configuration commands, Eeprom configuration commands, Figure 16. 8 kbyte eeprom memory organization – Cirrus Logic CS5376A User Manual

Page 28: Table 4. maximum eeprom configuration, Cs5376a

Advertising
background image

CS5376A

28

DS612F4

5 KByte (40 Kbit), which includes command over-
head:

Supported serial configuration EEPROMs are
SPI mode 0 (0,0) compatible, 16-bit addresses, 8-
bit data, larger than 5 KByte (40 KBit). ATMEL
AT25640, AT25128, or similar serial EEPROMs
are recommended.

8.4 EEPROM Configuration

Commands

A summary of available EEPROM commands is
shown in Table 5.

Write DF Register - 0x01

This EEPROM command writes a data value to the
specified digital filter register. Digital filter regis-
ters control hardware peripherals and filtering
functions. See “Digital Filter Registers” on page 86
for the bit definitions of the digital filter registers.

Sample Command:

Write digital filter register 0x00 with data value
0x070431. Then write 0x20 with data 0x000240.

01 00 00 00 07 04 31

01 00 00 20 00 02 40

Write FIR Coefficients - 0x02

This EEPROM command writes custom coeffi-
cients for the FIR1 and FIR2 filters. The first two
data words set the number of FIR1 and FIR2 coef-
ficients to be written. The remaining data words are
the concatenated FIR1 and FIR2 coefficients.

A maximum of 255 coefficients can be written for
each FIR filter, though the available digital filter
computation cycles will limit their practical size.
See “FIR Filter” on page 47 for more information
about FIR filter coefficients.

Sample Command:

Write FIR1 coefficients 0x00022E, 0x000771 then
FIR2 coefficients 0xFFFFB9, 0xFFFE8D.

02 00 00 02 00 00 02

00 02 2E 00 07 71 FF FF B9 FF FE 8D

Write IIR Coefficients - 0x03

This EEPROM command writes custom coeffi-
cients for the two stage IIR filter. The IIR architec-
ture and number of coefficients is fixed, so eight
data words containing coefficient values always
immediately follow the command byte. The IIR co-
efficient write order is: a11, b10, b11, a21, a22,
b20, b21, and b22. See “IIR Filter” on page 55 for
more information about IIR filter coefficients.

Figure 16. 8 Kbyte EEPROM Memory Organization

0000h

1FFFh

EEPROM
Manufacturing
Information

EEPROM
Command and
Data Values

Mfg Header

8-bit Command

0010h

N x 24-bit Data

8-bit Command
N x 24-bit Data

. . .

Table 4. Maximum EEPROM Configuration

Memory Requirement

Bytes

Digital Filter Registers (22)

154

FIR Coefficients (255+255)

1537

IIR Coefficients (3+5)

25

Test Bit Stream Data (1024)

3076

‘Filter Start’ Command

1

Total Bytes

4793

Advertising