Konica Minolta bizhub 282 - Manual (Page 139)

3 Basic copy operation
3-24 362/282/222
Ba
sic co
py ope
ra
tio
n
Chapter 3
3.5 Selecting a Paper setting
The paper size can be selected automatically according to the document
size or it can be specified manually. Specify the paper size according to the
corresponding procedure, depending on the desired copy settings.
2
Note
The factory default setting is “Auto Paper Select”.
As a factory default, the “Auto Zoom” setting and the “Auto Paper Select”
setting cannot both be selected at the same time. If the “Auto Paper Se-
lect” setting is selected while the “Auto Zoom” setting was selected, the
Zoom setting “×1.0” is selected.
However, the software switch settings can be used to allow the “Auto
Zoom” setting and the “Auto Paper Select” setting to be selected at the
same time. For details on the software switch settings, refer to “Specify-
ing software switch settings (machine functions)” on page 11-50.
Automatically selecting the paper size (“Auto Paper Select” setting)
The size of the loaded document is detected, and copies are produced using
paper of the same size.
If the “×1.0” Zoom setting was specified, paper of the same size as the doc-
ument is selected.
If the zoom ratio was increased or decreased, a paper size that corresponds
to the specified zoom ratio is automatically selected.
1
In the Basics screen,
touch [Paper].
The Paper screen ap-
pears.