Konica Minolta bizhub 282 - Manual (Page 72)

Before making copies 2
362/282/222 2-23
Be
fo
re
m
a
king
c
o
p
ie
s
Chapter 2
!
Detail
When the [Power] (auxiliary power) key is turned on, the indicator on the
[Start] key lights up in orange, and a screen indicating that the machine
is starting up appears.
After a few seconds, the message “Now warming up. Ready to scan.” ap-
pears on the touch panel, and the indicator on the [Start] key lights up in
green, indicating that a job can now be queued.
The default settings are the settings that are selected immediately after
the machine is turned on and before any setting is specified from the con-
trol panel or touch panel, and those that are selected when the [Reset]
key is pressed to cancel all settings specified from the control panel or
touch panel. The default settings can be changed. For more details, refer
to “Specifying User’s Choice settings” on page 11-9.
The factory default settings are the settings that were selected when this
machine was sent from the factory.
2
Note
A job can also be queued while the machine is warming up after the
[Power] (auxiliary power) key is turned on. For details, refer to “To scan
during warm-up” on page 2-24.
After the machine has finished warming up, the scanned image will be
printed.
The machine takes about 14 seconds to warm up at normal room tem-
perature (73.4°F) when the [Power] (auxiliary power) key is turned on after
the main power switch is turned on.