Konica Minolta bizhub 282 - Manual (Page 393)

11 Utility mode
11-52 362/282/222
Utility mode
Ch
apt
er
11
4
Touch either [Bit Selec-
tion] or [HEX Selection],
and then specify the set-
ting.
– To specify the bits,
touch [Bit Selection],
touch
and
to move the cur-
sor to the bit to be
changed, press ei-
ther the [0] or [1] key
in the keypad to
specify the bit, and then touch [Enter].
– To specify the hex
value, touch [HEX
Selection], specify
the value by either
using the keypad or
touching [A] through
[F], and then touch
[Enter].
5
To change the setting for a different mode, repeat steps 3 and 4.
6
Touch [Enter] in each screen until the initial screen appears.
7
Turn the machine off, then on again.
2
Reminder
When turning the main power switch off, then on again, wait about 10
seconds after turning the machine off before turning it on again. The ma-
chine may not operate correctly if it is turned on immediately after being
turned off.