Konica Minolta bizhub 282 - Manual (Page 357)

11 Utility mode
11-16 362/282/222
Utility mode
Ch
apt
er
11
Output Tray Settings
!
Detail
If the optional output tray are installed on the finisher, the factory default
setting for “Copy” is “3” (optional output tray).
2
Note
The “Output Tray Settings” parameter appears only if optional finisher or
job separator is installed.
Auto Paper Select for Small Orig.
Tab Parameter Description Default setting
5/6 Out-
put
Tray
Set-
tings Faxes/
Prints Fax Select the output tray for data re-
ceived at the fax port. 1 (output tray 1)
Port 2 Select the output tray for data re-
ceived at port 2 when the multi
port is installed. 1 (output tray 1)
Faxes/
Prints Select the output tray for data re-
ceived from the network. 1 (output tray 1)
Copier/
Printer Printer Specify the output tray for com-
puter printouts. 1 (output tray 1)
Copies Specify the output tray for cop-
ies. 2 (output tray 2;
when the job
separator is in-
stalled)
1 (output tray 1;
when the finish-
er is installed)
Tab Parameter Description Default setting
5/6 Auto Paper Select
for Small Original Select whether or not to specify a paper
tray when the “Auto Paper Select” set-
ting is selected and either no document
is placed on the original glass or the doc-
ument placed on the original glass is
smaller than 5-3/4 × 8-1/4.
• ON:
Copies are produced using the paper
given priority.
• Prohibit Copy:
The screen for selecting a paper tray
is displayed.
ON