Brother BES-962BC - Manual (Page 195)

Chapter 7 Operation of Machine
BES-962BC • BES-1262BC 193
4. Measures against Thread Breakage
4-1 Remedies
1. If embroidering is suspended due to thread
breakage, the THREAD SENSOR lamp of
the machine head with a thread breakage
blinks.
2. Correct the broken thread and pass it
through again.
* Refer to "Chapter 2, 3-1 Upper Threading" for details.
3. Press the STOP switch or press the STEP
BACK/FWD switch in order to reset the
alarm.
STOP
4. Return the hoop to a position where thread
breakage occurred by pressing the STEP
BACK switch.
or
Note) When the switch is turned for 20 stitches or
more, the machine continues operation with-
out holding the switch. To stop the machine,
turn the switch to the opposite side.
5. Press the START switch on the operation
panel or the start switch located between
the machine heads to resume operation.
or
THREAD
SENSOR lamp
HEAD switch
MENDING
lamp
STEP BACK/
FWD switch
MENDING
switch