Brother BES-962BC User Manual
Page 63
BES-962BC • BES-1262BC
61
Chapter 3 Embroidering Procedures
THREAD SENSOR lamp
When red light is on, thread breakage sensor is functioning. When the light is off,
the sensor is not effective. When the embroidery machine stops due to thread
breakage, the lamp flashes.
HEAD switch
When it is set to ON, needle bar on the head moves for embroidering. When it is
set to OFF, the needle bar does not move for embroidering.
MENDING lamp
This lamp lights up when the embroidery machine is in the mending mode.
MENDING switch
This switch is set to ON to drive or to suspend the machine head during
embroidering for a designated period of time.
STEP BACK/FWD switch
When it is turned to BACK, the machine steps back. When it is turned to FWD,
the machine steps forward. If you keep the switch turned for a while, the machine
will continue stepping even after you let the switch alone. When it is turned to the
opposite side, the machine stops.
During timing adjustment of the rotary hook in the test mode, the rotary hook
slightly rotates to the left/right when this switch is turned to left/right respectively.
Refer to "Adjustment of timing Between Needle and Rotary Hook" (
page 238)
for further details.