Brother BES-962BC User Manual
Page 53
Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC
51
Holder base (optional)
Attaching the holder base frame
1.
Set the table. (Refer to "2-4 Mounting of Table" (Page 32) for details.)
2.
Insert the frame connecting plate F
r
into the holder base frame LN
q
, holder base frame CN
w
, and holder base frame RN
e
, using bolts and washers.
3.
Remove four bolts
y
from the front of X-feed frame
t
. Attach one each of square nut M6
u
to the right and left sides at the front.
At the rear of the frame, attach three each of square nuts M6
u
to the right and left sides.
4.
Put frame connecting plates RN
i
and LN
o
on X-feed frame
t
. Fix them with bolts and
washers.
5.
Check that the clearance between the table and the mounted holder base frame C assembly
w
is even when viewed from the machine front.
[Adjustment]
Loosen three bolts of the F table support F
!0
and move it in the direction of the arrow for adjust-
ment.
w
q
q e
!1
1mm
1mm
t
i
w
!0
!2
o
o
r
e
i
y
u
y
Felt
Table
Do not remove
these screws.
!3
!3