Brother BES-962BC - Manual (Page 35)

Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC 33
1. Attach four hexagon socket head cap screws to each of F table parts R
q
, M (2 pcs)
w
, and
L
e
from the back.
2. Mount the F table parts from L
e
in order. Insert the bent part (lower) of F table guide UN
r
into the guide. Insert the F table rear pin into the hole of F table stopper N
t
.
3. Adjust F table supports F
y
in height so as to make the F table parallel with the floor.
4. Tighten all hexagon socket head cap screws
u
firmly.
r
y
Lower by 1 mm
Pin
u
t
q
w
e
For embroidering with tubular square hoop (middle position)