Brother BES-962BC - Manual (Page 51)

Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC 49
• By changing the tubular round arm mounting width, various sizes can be set.
Note) Change the width, referring to the pin position.
Note) If two pins cannot be inserted, remove one.
1. Move the end of the tubular round arm to
the left.
2. If a clearance is left as shown in the figure,
loosen screw
q
and adjust the tubular
round arm support so as to eliminate the
clearance between the support and the X-
feed frame. Tighten screw
q
.
* Follow the same steps when moving the
end face of a tubular round arm to the right.
• If a tubular round arm has a backlash:
Follow these steps for adjustment:
Screw q
Tubular round
arm support
360mm
400mm
500mm
600mm