Brother BES-962BC - Manual (Page 47)

Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC 45
2. Pass the thread through the upper hole of the pretension. Push up the thread guide tension
disc
w
with your finger, and pass it from the left to the lower hole.
3. Pass the thread through the upper hole of the 2nd pretension. Push up the thread guide
tension disc with your finger, and pass it from the left to the lower hole. Wind the thread
clockwise twice around thread breakage pulley
e
.
4. Pass the thread through the hole of upper thread guide(upper)
r
. Wind the thread clockwise
once around the rotary tension disc and place it on the spring.
5. Pass the thread through each hole of upper thread guide(middle)
t
and thread guide
y
.
6. After passing the thread through the hole of thread guide 6, insert the thread into the right
side of the inner thread guide and pass it through the hole of the thread take-up.
7. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper
section into thread guide A
u
.
8. Pass the thread through the hole of the needle bar thread guide
o
and pass it through the
needle eye. Do not pass it through the presser foot. Pass it to presser spring at the front of
lower thread guide
i
.
1. Pass an upper thread from the cotton stand through the hole of the thread guide right above
each cotton stand bar. Pass the thread from the back to the front hole.
The cotton stand (top view)
Pass a thread in the order
indicated in the figure.
Front