Brother BES-962BC - Manual (Page 248)

Chapter 11 Error code list
BES-962BC • BES-1262BC 246
Error
No error occurs.
Either motor of main shaft, X- or Y-axis, or lower
shaft has locked.
Overtravel occurs during home position detecting
movement.
The stop switch is pressed during home position de-
tecting movement.
Zero detecting movement out of range
Needle stop position error
Needle bar case position error
Needle bar case lock
Stop switch or emergency switch was pressed while
the needle bar case is traveling.
X-axis home position detection error
Thread breaking error
Stop or emergency stop during sewing
Insufficient bobbin thread
The machine does not return to the home position.
Mending finish
Undefined error
Y-axis home position error
Stop error during SSP processing (when pressing
the stop key while the hoop is moving)
The destination needle bar number given from PC is
out of the movable area.
The speed Vol. number given from PC is out of the
appropriate range.
X-axis stepping motor connector error
Destination coordinates error
The machine has reached the mending stop position.
The machine stops during mask tracing.
The machine stops while the needle is moving be-
tween patterns during repeat sewing.
Code
E-00
E-01
E-02
E-03
E-04
E-05
E-06
E-07
E-08
E-09
E-0A
E-0B
E-0C
E-0D
E-0E
E-0F
E-14
E-15
E-16
E-17
E-18
E-1A
E-1B
E-1C
E-1D
Measures
This is not usually displayed.
Turn the power off and on once. If the same error occurs again, the home
position sensor is faulty.
Press the
S T O P
or turn on the F/B switch on the head to either side to restart
the home position detecting movement again.
This is not usually displayed.
Adjust the pulley stop position (100 degrees) above the needle and press
the
STOP
or turn on the F/B switch on the head to either side.
This is not usually displayed.
Press the
STOP
or turn on the F/B switch on the head to either side. If the
same error occurs again, the color change mechanism is faulty.
This is not usually displayed.
Turn the power off and on once. If the same error occurs again, the X-axis
mechanism is faulty.
After passing through the thread, press the
STOP
or turn on the F/B switch on
the head to either side.
This is not usually displayed.
Turn the power off and on once.
This is not usually displayed.
Turn the power off and on once. If the same error occurs again, the Y-axis
mechanism is faulty.
Hoop movement restarts if you press .
This is not usually displayed.
Turn the power off and on once after checking to see that the connector of
the X-axis stepping motor is properly connected.
This is not usually displayed.
Tracing is cancelled if the
STOP
key is pressed when the machine is stopped
during mask tracing. Press the key to continue tracing.
This is displayed when the stop switch is pressed while the hoop is moving.
Press the
to move the hoop again. (It is necessary to press the
again to start sewing.)
Errors E-1C and E-1D are not displayed due to mechanical problems.