Lukas P 650 Series - Manual (Page 10)

10
3. Intended use
You can obtain accessories and replacement parts for the rescue apparatus from your
authorised LUKAS dealer!
WARNING / CAUTION / ATTENTION!
Always observe the safety notes of these operating instructions with regard to
place of installation and type of installation!
Type P 650 units manufactured by LUKAS are
not explosion-proof!
LUKAS hydraulic units are specially designed to supply LUKAS rescue equipment with
hydraulic
À uid so that this equipment can be used to rescue victims of road, rail or air traf¿ c
accidents as well as from buildings.
Their use for supplying pressure /
À uid to rescue equipment of other manufacturers is
possible, yet requires the technical inspection and approval by LUKAS in each individual
case.
CAUTION!
When selecting a device for connection, remember that the maximum possible
useable volume of the hydraulic
À uid is limited.
The maximum total volume of hydraulic
À uid required by all connected devices
must not exceed the maximum possible useable volume of the unit!
Due to the limited useable volume, a maximum of 2 rescue rams can be
connected for reasons of safety (only at maximum
¿ ll quantity).
Type R424 cylinders are an exception to the rule, however.
Two of these cylinders should never be coupled and operated
simultaneously!
NOTE:
Always register your hydraulic unit on the LUKAS Hydraulik GmbH website.
This is the only way to guarantee your extended warranty cover.
You must always contact LUKAS or an authorised dealer before using couplings
from another manufacturer.
The power units were not developed for being operated without hoses or devices
(operating time < 15 minutes).