Lukas P 650 Series - Manual (Page 47)

47
Trouble Check Cause Solution
Combustion
engine will not
start Check fuel level
in tank Fuel tank empty Top up fuel
Electric starter
present? Electric starter battery
À at Charge electric starter
battery or use pull cord
starter
Check fuel line Fault in the fuel line Shut down immediately
and have repaired by
authorised dealer, motor
/ engine manufacturer or
directly by LUKAS
Check the starter
button and
engine switch Starter button or pull
cord starter not
actuated Actuate starter button or
pull cord starter
Engine switch not set
to “Choke” Set engine switch to
“Choke”
Hydraulic unit or
motor / engine
not suitable
for the working
environment Ambient temperature
too low For the solution,
consult the separate
operating instructions
of the engine / motor
manufacturer.
Use a different hydraulic
or operating
À uid that
is suitable for the
corresponding ambient
temperatures (see
chapter “Technical data”)
Not enough oxygen in
the air because of the
altitude of application
location of the
hydraulic motor Use a different more
suitable hydraulic unit.
Have the engine set to
the altitude of application
by an authorised
dealer, motor / engine
manufacturer or LUKAS
directly (only if the unit is
to be used frequently at
this altitude).
Check air
¿ lter
Air
¿ lter contaminated
Clean or replace the air
¿ lter.
Are all valves
depressurised
(base position)? Combustion
engine defective or
overloaded due to
another defect in the
unit Have repaired by
authorised dealer, motor
/ engine manufacturer or
directly by LUKAS