Lukas P 650 Series - Manual (Page 16)

16
5.8 Hose reels
The hose reels were designed to store extension hose pairs leading between the hydraulic
supply and the working equipment (hose pairs are included in the delivery as standard).
The extension hose pairs are connected to the hose reels and rolled onto the drums.
A hose reel with extension hose pairs can cover long distances between the hydraulic supply
and the working equipment, allowing you to keep the hydraulic unit on a vehicle, for example.
The possibility of rolling up and unrolling the hose allows you to adapt the hose length
accordingly and reduce the amount of unnecessary or potentially dangerous excess hose
lying on the ground.
The extension hose pairs are easier to transport and store when fully rolled up.
Moreover, the hose reels on type P650 units are equipped with a hose guide that facilitates
easier rolling up and unrolling.
The unit is connected to the working equipment via couplings.
CAUTION!
In order to avoid potential losses in pressure, the length of the extension hose
lines must not exceed 30 m!
5.9 Carrying handle
Type P650 LUKAS hydraulic units without a hose reel can be
¿ tted with optional carrying
handles. The scope of delivery of units with a hose reel already includes handles.
The P650 can be transported more ergonomically using the carrying handles.
NOTE:
Only 2 of the 4 connections can be connected to the hose reel on type
P 650 4G units.
There are 2 coupling connections located between the two reel drums for the
remaining two connections. The lower of the two connections is extendable to
allow easier coupling. It also engages easily in the end positions.
The switches and connections are labelled to make them easier to assign to one
another.
5.10 Toolholder
Type P650 LUKAS hydraulic units with a hose reel are ¿ tted with a Toolholder.
The Toolholder is usually designed to attach a spreader and a type S700 cutter.
Needless to say, it is possible to adapt the mount to accommodate all LUKAS cutters and
spreaders as well as modify it at a later date.
The Toolholder allows you to transport a unit with devices still attached.
You no longer have to detach and store devices separately after use. You only have to wind
the hose lines onto the reels and position the devices on the Toolholder again.
Devices secured to the unit do not pose a risk during transport.