Lukas P 650 Series - Manual (Page 28)

28
Procedure (fi tting and adjusting the Toolholder):
1. Mount the retaining clip "A" on block "C" and
secure using the screws "B".
2. Secure the two brackets "D" and "E" to mounting plate "G" using screws "F".
NOTE:
If you wish to install a Toolholder at a later time or adapt an existing mount to a
new device, follow the working steps described below.
A
B
C
G
J
K
R
O
Position for S 700
G
F
D
E
S
K
R
Using cutter models S700, it must be proceeded as
follows with the retainer. Because of the size of the
cutters the bracket "J" must be installed on mounting
block "R" using screws "O". Mounting block "R" is
then secured to mounting plate "K" using screws "S".