JLG 18RS Service Manual - Manual (Page 89)

SECTION 4 - BOOM & PLATFORM
3121284 – JLG Lift – 4-9
and cables are pushed to the outside of the curve in
the power track. Adjust the loop of hoses between
the power track and carrier tube (See Figure 4-8.,
Hose Adjustment - Figure 5) so that the minimum
distance between the carrier tube and hoses match
the dimension shown below. 11. Tighten hose clamp at location “D” (Figure 4-6.,
Hose Adjustment - Figure 4) until hoses are tight and
unable to be moved.
A
B
C
D Torque to 54 ft.lbs. (73 Nm)
Loctite #242
Torque 565 ft. lbs. (766 Nm)
Check torque every 150 hours of operation
Figure 4-9. Platform Support Torque Values
NOTE: If any rotator bolts are replaced,
all bolts on the rotator should
be retorqued.