JLG 67SL Service Manual - Manual (Page 54)

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3-22 – JLG Lift – 3121322
Hydraulic Tank
Removal:
1. Shut the two valve levers (6) at the base of the tank
to turn off flow of hydraulic fluld. Drain hydraulic fluid
by opening the drain port on underside of the
Hydraulic Tank (1). Store fluid in appropriate recep-
tacle. Disconnect all hoses.
2. Remove hydraulic tank by removing the four Cap-
screws (2), Nuts (4) and eight Flatwashers (3).
3. Carefully remove the tank from the engine compart-
ment.
Installation:
1. Place tank into engine compartment lining up the
bolt holes.
2. Replace Capscrews, Flatwashers and Nuts into their
respectable holes. Tighten.
3. Replace all hydraulic hoses.
4. Ensure the drain port is closed.
5. If required, replace Filter.
6. Remove Filler cap (5) and fill tank with hydraulic fluid
to its designated capacity, 37 gal (135 L).
7. Open valve lever to turn on flow of hydraulic fluid.
1 2, 3, 4
2,
3,
4
5
Figure 3-20. Hydraulic Tank Removal
1. Hydraulic Tank
2. Capscrew, M10 x 25mm
3. Flatwasher, M10 (2 per capscrew)
4. Nut, M10
5. Filler
6. Shutoff Valve Levers