JLG 67SL Service Manual - Manual (Page 63)

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3121322 – JLG Lift – 3-31
Extension Side Rails
NOTE: Stow or remove the Extension End Rail before
removing the Extension Side Rails. (See the proce-
dures on the previous page).
Removal:
NOTE: Procedures apply to both left and right sides.
1. Remove the Spring Cotters (2) on each leg of the
Side Rail (1).
2. Carefully fold the rails inward to the stowed position.
3. Remove the rail by removing the Capscrews (3),
Locknuts (4), and Washers (5) from each leg of the
rail.
NOTE: Extension side rails weigh approximately 43 lbs
(19.5 kg) each.
Installation:
NOTE: Procedures apply to both left and right sides.
1. Carefully place extension side rails on the platform
in their stowed position, lining up the bolt holes on
the rail legs with the appropriate connecting points
on the platform.
2. Follow the removal procedures in reverse order.
1
2
3
4
5
1. Extension Side Rail
2. Spring Cotter
3. Capscrew, M10 x 80mm
4. Locknut, M10
5. Washer, 10mm
Figure 3-29. Extension Side Rail Removal