JLG 67SL Service Manual - Manual (Page 65)

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3121322 – JLG Lift – 3-33
Main Platform Side Rails
NOTE: Stow or remove Main Platform End Rails and Plat-
form Extension Side Rails before removing the Main
Platform side rails. (See instructions on previous
pages).
All removal procedures apply to both left and right
sides.
Removal:
1. Remove the two Hairpin Springs (2) on each leg of
the rail.
2. The Chain Assemblies can be removed from the
platform by removing the Bolts (3), Nuts (4), and
Flatwashers (5).
3. Carefully fold the rails inward to the stowed position.
4. Remove rails from the platform by removing the
Capsrews (6), Locknuts (7), and Washers (8) from
the legs on each rail.
NOTE: Each side rail weighs approximately 43 lbs (19.7 kg).
NOTE: Procedures below apply to both left and right sides.
Installation:
1. Carefully place side rails on the platform in their
stowed position, lining up the bolt holes on the rail
legs with the appropriate connecting points on the
platform.
2. Follow the removal procedures in reverse order.
1
2
3
4 5
6, 7, 8
1. Side Rail
2. Hairpin Spring, M4
3. Bolt, M8 x 20mm
4. Nut, M8
5. Flatwasher, M8
6. Capscrew, M10 x 80mm
7. Locknut, M10
8. Washer, 10mm
Figure 3-31. Side Rails Removal