Pressure filter, Pressure filter -23, Pressure filter removal -23 – JLG 67SL Service Manual User Manual
Page 55
Advertising
SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3121322
– JLG Lift –
3-23
Pressure Filter
Removal:
1.
Disconnect hose(s) from the Pressure Filter (1).
2.
Loosen and remove the four Capscrews (2) and
Lockwashers (3).
3.
Remove the Pressure Filter.
Installation:
1.
Align the pressure filter so that the screw holes
match up with the screw holes on the holding
bracket.
NOTE: Be sure arrow on top of filter points towards the
hydraulic tank.
2.
Insert the four Lockwashers and Capscrews into the
holes and tighten.
3.
Reconnect any hose(s) disconnected during
removal.
1
2, 3
1.
Pressure Filter
2.
Capscrew, M10 x 20mm
3.
Lockwasher, M10
Figure 3-21. Pressure Filter Removal
Advertising