JLG SSV10 Operator Manual - Manual (Page 13)

SECTION 1 - SAFETY PRECAUTIONS
3121186 – JLG Lift – 1-3
1.3 OPERATION
General
• Do not use the machine for any purpose other than posi-
tioning personnel, their tools and equipment, or for hand
stock picking.
• Never operate a machine that is not working properly. If a
malfunction occurs, shut down the machine.
• Never slam a control switch or lever through neutral to an
opposite direction. Always return switch to neutral and
stop before moving the switch to the next function. Oper-
ate controls with slow and even pressure.
• Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
• Do not carry materials directly on platform railing unless
approved by JLG.
• Always ensure that power tools are properly stowed and
never left hanging by their cord from the platform work
area.
• Fully lower mast assembly and shut off all power before
leaving machine.
• No riders are permitted on machine. Operator only in
machine during operation.
• When performing welding operations at elevation, precau-
tions must be taken to protect all machine components
from contact with weld splatter or molten metal.
• Battery fluid is highly corrosive. Avoid contact with skin
and clothing at all times.
• Charge batteries on in a well ventilated area.
Trip and Fall Hazards
• JLG Industries, Inc. recommends that the operator in the
platform wear a full body harness with a lanyard attached
to an authorized lanyard anchorage point. For further
information regarding fall protection requirements on JLG
products, contact JLG Industries, Inc.
• Before operating the machine, make sure all railing and
gates are fastened in their proper position.
SECTION 1 - SAFETY PRECAUTIONS
3121186 – JLG Lift – 1-3
1.3 OPERATION
General
• Do not use the machine for any purpose other than posi-
tioning personnel, their tools and equipment, or for hand
stock picking.
• Never operate a machine that is not working properly. If a
malfunction occurs, shut down the machine.
• Never slam a control switch or lever through neutral to an
opposite direction. Always return switch to neutral and
stop before moving the switch to the next function. Oper-
ate controls with slow and even pressure.
• Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
• Do not carry materials directly on platform railing unless
approved by JLG.
• Always ensure that power tools are properly stowed and
never left hanging by their cord from the platform work
area.
• Fully lower mast assembly and shut off all power before
leaving machine.
• No riders are permitted on machine. Operator only in
machine during operation.
• When performing welding operations at elevation, precau-
tions must be taken to protect all machine components
from contact with weld splatter or molten metal.
• Battery fluid is highly corrosive. Avoid contact with skin
and clothing at all times.
• Charge batteries on in a well ventilated area.
Trip and Fall Hazards
• JLG Industries, Inc. recommends that the operator in the
platform wear a full body harness with a lanyard attached
to an authorized lanyard anchorage point. For further
information regarding fall protection requirements on JLG
products, contact JLG Industries, Inc.
• Before operating the machine, make sure all railing and
gates are fastened in their proper position.