JLG SSV10 Operator Manual - Manual (Page 42)

SECTION 3 - MACHINE OPERATION
3-14 – JLG Lift – 3121186
In the LCD Display Symbols (previous illustration - item-2), the
Function Display or Function Disabled Indicators will vary as
shown following: Tilt Alarm Warning
THE GROUND CONTROL STATION CONTAINS A 1.5 DEGREE TILT
ALARM, IF THE TILT ALARM HAS BEEN ACTIVATED, THE PLATFORM
WILL NOT ELEVATE. ALSO IF THE TILT ALARM HAS BEEN ACTIVATED
WHEN THE PLATFORM IS ELEVATED, THE DRIVE AND LIFT UP FUNC-
TIONS WILL BE DISABLED UNTIL THE PLATFORM IS COMPLETELY
LOWERED AND DRIVEN OFF THE TILT CONDITION.
LCD Display Fault Conditions
Table 3-3 following shows common LCD display Fault indicators
which may occur during operation and are usually caused by
either an error in machine operation or a work area condition.
These fault conditions can usually be corrected by the operator
and do not require a qualified mechanic to repair:
IMPORTANT
AFTER A FAULT CONDITION IS CORRECTED THE MACHINE POWER
MAY NEED TO BE RECYCLED TO RESET THE GROUND CONTROL STA-
TION.
DRIVE Disabled
LIFT UP Disabled
LIFT DOWN Disabled
Both LIFT UP and LIFT DOWN
Disabled
Drive Speed Cut-Back (Turtle) Mode
Engaged (When Platform is Elevated)
Battery Charger (AC) Plugged In
SECTION 3 - MACHINE OPERATION
3-14 – JLG Lift – 3121186
In the LCD Display Symbols (previous illustration - item-2), the
Function Display or Function Disabled Indicators will vary as
shown following: Tilt Alarm Warning
THE GROUND CONTROL STATION CONTAINS A 1.5 DEGREE TILT
ALARM, IF THE TILT ALARM HAS BEEN ACTIVATED, THE PLATFORM
WILL NOT ELEVATE. ALSO IF THE TILT ALARM HAS BEEN ACTIVATED
WHEN THE PLATFORM IS ELEVATED, THE DRIVE AND LIFT UP FUNC-
TIONS WILL BE DISABLED UNTIL THE PLATFORM IS COMPLETELY
LOWERED AND DRIVEN OFF THE TILT CONDITION.
LCD Display Fault Conditions
Table 3-3 following shows common LCD display Fault indicators
which may occur during operation and are usually caused by
either an error in machine operation or a work area condition.
These fault conditions can usually be corrected by the operator
and do not require a qualified mechanic to repair:
IMPORTANT
AFTER A FAULT CONDITION IS CORRECTED THE MACHINE POWER
MAY NEED TO BE RECYCLED TO RESET THE GROUND CONTROL STA-
TION.
DRIVE Disabled
LIFT UP Disabled
LIFT DOWN Disabled
Both LIFT UP and LIFT DOWN
Disabled
Drive Speed Cut-Back (Turtle) Mode
Engaged (When Platform is Elevated)
Battery Charger (AC) Plugged In