JLG SSV10 Operator Manual - Manual (Page 37)

SECTION 3 - MACHINE OPERATION
3121186 – JLG Lift – 3-9
3.6 HOOD - (CARRY DECK)
To Remove the Carry Deck Hood:
1. To remove the hood, pull UP on each of the hood latch han-
dles (until pointing straight out) to release it from the hood
mount supports beneath the hood.
2. Starting with the rear hood latches, lift the hood up enough
to clear the rubber sealing gasket on the base frame and pull
out on each hood latch clear of the mount support under the
hood. Lift the front of the hood and slide the front hood latch
forward out of it’s mount support to completely remove the
hood off the machine.
NOTE: The maximum capacity for the Carry Deck is 250 lb.
(115kg).
DO NOT ALLOW ANY PERSONNEL TO RIDE ON THE CARRY DECK
HOOD.
Figure 3-4. Carry Deck - Hood Removal.
1. Hood - Carry Deck 2. Hood Latches
SECTION 3 - MACHINE OPERATION
3121186 – JLG Lift – 3-9
3.6 HOOD - (CARRY DECK)
To Remove the Carry Deck Hood:
1. To remove the hood, pull UP on each of the hood latch han-
dles (until pointing straight out) to release it from the hood
mount supports beneath the hood.
2. Starting with the rear hood latches, lift the hood up enough
to clear the rubber sealing gasket on the base frame and pull
out on each hood latch clear of the mount support under the
hood. Lift the front of the hood and slide the front hood latch
forward out of it’s mount support to completely remove the
hood off the machine.
NOTE: The maximum capacity for the Carry Deck is 250 lb.
(115kg).
DO NOT ALLOW ANY PERSONNEL TO RIDE ON THE CARRY DECK
HOOD.
Figure 3-4. Carry Deck - Hood Removal.
1. Hood - Carry Deck 2. Hood Latches