2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 26)

2N® SmartGate UMTS parameters configuration 3.1
26
Installation and setting of SmartGate PCManager (Win7)
1. Connect 2N ® SmartGate UMTS to the PC using USB connection. SmartGate
must be switched off.
2. After connecting is the virtual serial port in PC installed automatically. I case,
that the port doesn’t install automatically and unknown device is detected,
install drivers by using file: Drivers/win/CDM20814_Setup.exe.
3. Find the number of virtual port using Device manager. Look at setting of COM
ports and find port marked as USB Serial Port(COMn).
4. Install PCManagerSmG from CD.
5. Run SmartGate PCManager, select the language on the upper bar.
6. In menu Program select Setup. Set the COM port – local and select COM port
number according information from point 3.
Using of PCManager - basic
1. The main purpose of PCManager is setting of configuration and upgrade
firmware of SmartGate.
2. When the configuration in SmartGate should be changed, the configuration
must be first loaded from SmartGate, than edited using PCManager and finaly
loaded back to SmartGate.
3. The groups of parameters are listed is in the left window of the program. All
parameters are described in next part of this manual. There is interactive help
in PCManager for all parameters.
4. When you start with any operation which needs communication with
SmartGate, the gateway must be switched to special programming mode.
PCManager will show you the demand to switch the gateway off and on to set it
to this mode.
Further Data Handling Options
In addition to the 2N® SmartGate UMTS memory, settings can be saved in a PC file
and reloaded into the PCManager. This is recommended for backing up of current
configuration
Caution
n The table Security includes the PIN code and service password. These
parameters have a special handling. They are not saved in a PC file for
security reasons. If you load a PC file into the PCManager and then into
SmartGate UMTS, the PIN and service password should not change unless
you change them manually before saving.