2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 47)

Table of Parameters 3.2
47
SMS Sending Input Parameters
Telephone number for SMS Function No.:600
The telephone number to which an SMS is sent upon SMS input activation. If
blank, the function is off.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
SMS text Function No.: -
The SMS text to be sent to the preset telephone number. If the SMS text is
blank, SMS with signal strength is sent.
Setting options: 0-40 characters
Default setting: blank
Send if activated longer than [ms] Function No.: 601
Set the SMS activation time necessary for SMS sending. This parameter prevents
SMS sending in the event of short-time activation. If a "0" is selected, SMS is
sent immediately upon the input activation.
Setting options: 0-25500 ms
Setting step: 100 ms
Default setting: 0 ms
Timeout after sending [s] Function No.: 602
Set the Time of inactivity after SMS sending. During this timeout no SMS is sent
even if the SMS input gets activated. This prevents sending multiple SMS units in
the case of repeated activation of the input.
Setting options: 0-2550 s
Setting step: 10 s
Default setting: 0 s
GSM & SIM Parameters
UMTS/GSM operator lock Function No.: -
Provider blocking is set by manufacturer in SmartGate UMTS. If 2N® SmartGate
UMTS is blocked to a UMTS/GSM provider, no other UMTS/GSM provider's SIM
card can be used. If an unacceptable SIM card is used, the UMTS/GSM module
does not register to UMTS/GSM and the UMTS/GSM network LED flashes quickly
on the 2N® SmartGate UMTS panel.
CLIR - incognito Function No.: 701
Sets the calling line identification restriction (CLIR) for outgoing calls from
SmartGate UMTS. Attention, before enabling it is necessary to activate this
feature by UMTS/GSM operator, otherwise outgoing calls can be rejected by
UMTS/GSM network.