2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 58)

Voice function 4.1
58
Configuration of network services
2N® SmartGate UMTS provides some of network services to improve possibility of
usage. The configuration is done by standard Star-Hash codes you can know from
mobile phones.
To configure these services:
1. Hook off the telephone, you can hear the dial tone.
2. Enter the Star-Hash code described below.
3. Wait for information tone. You may wait about 3 seconds.
4. Hook on.
Information tones:
Confirmation - OK:
n Confirms that the service was configured correctly.
Confirmation - bad:
n Service was not correctly configured
n Service isn’t activated by your provider
Confirmation - service activated:
n Confirms that the service was configured correctly and the service is
activated.
Confirmation - service deactivated:
n Confirms that the service was configured correctly and the service is
deactivated.
Call forwarding
For forwarding activation you must specify <Telephone number> the calls will be
forwarded to. You may specify <Call type>, if you want to forward specified call
type only. You may specify <Delay time> in seconds for forwarding if no answer
too.
Description of <Call type> field codes:
Voice:
Data:
Fax: