2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 44)

Table of Parameters 3.2
44
End with # Function No.: 494
This parameter enables to establish the call when a # is received. The #
character is removed from the dialed number. If a # should be part of the dialed
number, this function cannot be used for the given prefix.
Setting options: YES(1)/NO(0)
Default setting: NO
Remove FunctionNo.: 495
The Remove parameter is used for automatic call routing. A defined count of
digits (prefix) is removed from the number beginning.
Setting options: 0-20
Setting step: 1
Default setting: 0
Add Function No.: 496
The Add parameter is used for automatic call routing. A defined string (prefix) is
added to the beginning of the number to be dialed.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Time limit [min] Function No.: 499
After time elapsing is call connection terminated immediately. You can hear beep
30s before end of call. 10s before end you can hear beep every second. The "0"
setting means that the function is disabled.
Setting options: 0-255 min
Setting step: 1 min
Default setting: 0 min
UMTS/GSM routing table
All parameters related to the dialed number and call routing are arranged in three
routing tables. Each table pertains to one interface: FXS, FXO and UMTS/GSM.
Incoming calls from UMTS/GSM contain the CLI. According to received CLI 2N®
SmartGate UMTS can do following:
· Reject the call;
· Route the call to FXS or FXO interface;
· Automatic dial in. 2N® SmartGate UMTS dials preprogrammed PBX subscriber
number (for example switchboard operator) to be connected with calling
UMTS/GSM subscriber.
FXS line Off-Hook to DISA timeout [ms] Function No.: 500
Timeout between FXS line Off-Hook and automatic dial in according to parameter
"Dial in" in the table.
Setting options: 100-25500 ms
Setting step: 100 ms
Default setting: 2000 ms