2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 37)

Table of Parameters 3.2
37
Setting options: 1-3400 Hz
Setting step: 1 HzD
efault setting: 425 Hz
Dial tone – frequency 2[Hz] Function No.: 221
Setting of frequency 2 of dial tone.
Setting options: 1-3400 Hz
Setting step: 1 Hz
Default setting: 425 Hz
Dial tone - cadence Function No.: 222
Dial tone cadence setting.
Setting options: Continuous ( 0) -2N® SmartGate UMTS generate
continuous dial tone
Morse A (1) -2N® SmartGate UMTS generate dial tone
with 330/330/660/660 ms timing
Default setting: Continuous
Ring back tone – frequency 1 [Hz] Function No.: 226
Setting of frequency 1 of ringback tone. This tone is send after dialing end,
before UMTS/GSM network starts to generate its own Ringback tone.
Setting options: 1-3400 Hz
Setting step: 1 Hz
Default setting: 425 Hz
Ringback tone – frequency 2 [Hz] Function No.: 227
Setting of frequency 2 of ringback tone.
Setting options: 1-3400 Hz
Setting step: 1 Hz
Default setting: 425 Hz
Ringback tone - cadence Function No.: 228
Ringback tone cadence setting.
Setting options: OFF (0) -not generated, only network tone
1000/4000 ms (1) -cadence 1 s tone, 4 s pause
400/200/400/2000 ms (2) -cadence 2x400 ms tone,
2 s pause
1500/3500 ms (3) -cadence 1,5 s tone, 3,5 s pause
2000/4000 ms (4) -cadence 2 s tone, 4 s pause
Default setting: OFF
Volumes
Transmission volume Function No.: 190
See FXS interface parameters.